Introduction to the Equipment we own

Machining Center
ENSHU VMC40

We have been using this machining center for over 30 years, and it is still in active service. It can perform powerful cutting operations.

Machining Center
TSUGAMI　VA1-II

This machining center is small, but its precision is excellent. Since we purchased it right after it was released, its serial number is very low.

Wire Cut
FANUC α0iD

We introduced it 10 years ago. Its precision is extremely high.

Wire Cut
FANUC α0iB

Although we introduced it 20 years ago, it is still operational. Compared to the α0iD, its processing speed and precision are inferior, but it is still usable.

Lathe
OKUMA　LS Type

This is a large and extremely powerful lathe. It boasts excellent power and precision. We have been using it for nearly 40 years.

Lathe
WASHINO　LR-55A

This is a small lathe that is very user-friendly. It is suitable for fine work.

OKAMOTO Surface grinder

It is a machine used for polishing the surfaces of metals.

ENSHU Slice

It can perform various operations manually.

Drill press
KIRA　KID-420 x3

This is a manual drill press. Basically, it is a machine used for drilling holes. It may also be used for other purposes.

Measureing Machine
NIKON　MM-400/T
NIKON　E-MAX(Measurement Support System)

This is an opportunity to perform precise measurements using a PC and an electron microscope. I have been informed that the margin of error is about 0.01, regardless of how poorly it may be functioning.

Measureing Machine
mitsutoyo PJ300

This is an opportunity for manual measurement. It is used when quick and easy measurements are desired.

Software
autodesk Fusion360

It is used for creating NC data, but it is also useful for drafting drawings and creating component diagrams.

Software
SingleDNC

This is software that enables data transmission and reception with the VMC40 via a serial cable from the PC. In the past, we used floppy disks, but since implementing this system, data exchange has become much easier.